Trunking System; Off-Hook Decode; Monitor - Kenwood TK-3180 Function Reference

18 SIGNALING
!
Configuration using KPG-89D
•
Configuring the Signaling (Decode) (Refer to
FPRG 6.2.5 Optional Signaling Decode Condition.)

18.4.2 Trunking System

The LTR ID must be matched in Trunking Systems.
Therefore, the condition to decode the Signaling in
Trunking system is the LTR ID Decode only.
The transceiver decodes the optional signaling and starts
performing the Call Alert Beep, Call Alert, and Transpond
functions when the optional signaling matches after it is
decoded.
When optional signaling matches, it remains in the match
state until it is reset.

18.5 Off-hook Decode

(TK-7180/ 8180 only)
This function allows a user to operate Carrier Squelch
and release the Signaling and optional signaling in
conjunction with the Mic hook status.
The Mute function is disabled regardless of the Mic hook
status in the following conditions when the Off-hook
Decode is enabled.
• The QT/DQT is matched.
• The optional signaling matches according to the Audio
Control configuration.
You can enable/disable the Off-hook Decode function
using KPG-89D.
Note:
" This function is available only in the TK-7180/ 8180.
" The Stun function is activated regardless of the Off-hook
Decode function and the Mic hook status.
" The match state of the optional signaling resets when the Mic
hook enters On-hook status after receiving the call with optional
signaling.
!
Configuration using KPG-89D
• Configuring the Off-hook Decode (Refer to FPRG
6.7.1 Common-Page 1 tab - Off-hook Decode.)
70

18.6 Monitor

This function allows the transceiver to unmute and enter
receive mode. The operation of this function varies
between a Conventional Group and a Trunking system.
This function allows a user to monitor the channel before
transmitting.
Press the PF Monitor key or the PF Monitor Momentary
key when using this function.
!
Transceiver Operation
# PF Monitor key
1. Press the PF Monitor key.
The "
The QT/DQT Signaling becomes inactive when
the QT/DQT Decode function is configured to
the channel and a user can hear the audio
signal every time the transceiver receives
carrier.
TK-2180/ 3180
TK-7180/ 8180
2. Press the PF Monitor key.
The "
If the QT/DQT is configured to the current
channel, the transceiver returns to Signaling
Squelch.
TK-2180/ 3180
TK-7180/ 8180
Function Reference
"appears.
" icon disappears.
a
Version: 1.11