Maximum Volume; Tone Volume Offset; Tone Volume - Kenwood TK-3180 Function Reference

4 SOUND
!
TK-7180/ 8180
# Selecting "Preset" in Minimum Volume Type
The volume of the transceiver is automatically
configured to the Minimum Volume level when the
transceiver is turned ON even if the volume level
was completely turned down and the transceiver
was turned OFF.
# Selecting "Lowest Limit" in Minimum Volume
Type,
This function allows you to limit the Minimum
Volume level when the Volume control is turned to
its lowest level.
This prevents the user from missing calls even if
the Volume control has been turned down. The
volume increases from the Minimum Volume Level
when turning the Volume control clockwise. The
transceiver mutes completely when turning the
Volume control to the full counterclockwise
position if the Minimum Volume is not configured.
!
Configuration using KPG-89D
• Configuring the Minimum Volume (Refer to FPRG
6.7.2 Common-Page 2 tab - Minimum Volume.)
• Configuring the Minimum Volume Type (Refer to
FPRG 6.7.2 Common-Page 2 tab - Minimum
Volume Type.)
4.3

Maximum Volume

(TK-2180/ 3180 only)
This function allows you to limit the maximum volume
level when the Volume control is turned to fully clockwise.
This prevents a user from excessive volume when
wearing the headset.
You can configure this function using KPG-89D.
!
Configuration using KPG-89D
• Configuring the Maximum Volume (Refer to FPRG
6.7.2 Common-Page 2 tab - Maximum Volume.)
26
4.4

Tone Volume Offset

This function allows you to configure the offset level from
the volume level. You can use this function when
adjusting the volume level of the tone.
You can configure this function using KPG-89D.
!
Configuration using KPG-89D
•
Configuring the Tone Volume Offset (Refer to
FPRG 6.7.2 Common-Page 2 tab - Tone Volume
Offset.)
4.5

Tone Volume

You can configure the volume level of various tones using
KPG-89D.
You can use this function when adjusting the volume level
of the tone.
You can configure the Tone Volume for each tone using
KPG-89D. You can configure the volume of the following
tones.
Tone Volume
Current
1 - 31
Off
Selectable
!
Configuration using KPG-89D
• Configuring the Power-on Tone (Refer to FPRG
6.7.2 Common-Page 2 tab - Power-on Tone.)
• Configuring Control Tones (Refer to FPRG 6.7.2
Common-Page 2 tab - Control Tone.)
• Configuring Warning Tones (Refer to FPRG 6.7.2
Common-Page 2 tab - Warning Tone.)
• Configuring Alert Tones (Refer to FPRG 6.7.2
Common-Page 2 tab - Alert Tone.)
• Configuring Sidetones (Refer to FPRG 6.7.2
Common-Page 2 tab - Sidetone.)
• Configuring Locator Tones (Refer to FPRG 6.7.2
Common-Page 2 tab - Locator Tone.)
Function Reference
Table 4-7 Available Tone Volume
Operation
The current tone operates in conjunction
with the Tone Volume.
The transceiver emits tones with the fixed
tone volume. Higher values result in greater
volume.
The transceiver does not emit any tones.
The tone volume changes in conjunction
with the PF Fixed Volume key.
4.6 Selectable Tone Level.)
(Refer to
Version: 1.11