Dodge 2016 GRAND CARAVAN User Manual page 31

Power Lumbar
Vehicles equipped with power driver or passenger seats may also be equipped with power
lumbar. The power lumbar switch is located on the outboard side of the power seat. Push
the switch forward to increase the lumbar support. Push the switch rearward to decrease
the lumbar support.
Driver Memory Seat
The Memory Buttons 1 and 2 on the driver's door panel can be programmed to recall the
driver's seat, outside mirrors, and radio station preset settings. Your Remote Keyless Entry
(RKE) transmitters can also be programmed to recall the same positions when the
UNLOCK button is pushed.
Your vehicle may have been delivered with
two RKE transmitters, one RKE transmitter
can be linked to each of the memory posi-
tions.
Programming The Memory Feature
NOTE:
To create a new memory profile, perform the following:
1. Cycle the vehicles ignition to the ON/RUN position (do not start the engine).
2. Adjust all memory profile settings to desired preferences (i.e., driver's seat, outside
mirrors, adjustable pedals [if equipped] and radio station presets).
3. Push and release the S (Set) button on the memory switch.
4. Within five seconds, push and release either of the memory buttons (1) or (2). The
Electronic Vehicle Information Center (EVIC) will display which memory position has
been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
• To set a memory profile to your RKE transmitter, refer to "Linking And Unlinking The
Remote Keyless Entry Transmitter To Memory" in this section.
G E T T I N G S T A R T E D
Driver Memory Switch
29