Led Status Display; Troubleshooting - Canton Musicbox S User Manual

English

LED status display

LED Colour
Power steady blue
Power steady blue
Power Flashing blue
Power Flashing red
Power Rapid flashing red (2x/sec.)
Bluetooth Flashing blue
®
Bluetooth steady blue
®
Bluetooth Flashing white
®
Bluetooth ® /auX Off
auX steady blue
Mute Flashing white
Mute 5 seconds steady white
Centerpad Flashing blue left or right
Centerpad steady blue left
Centerpad steady blue right
Centerpad steady blue left and right
Note: in battery operation all leds are switched off after approx. 5 seconds to
save power consumption. Only the led display of the selected input remains active.
42
Meaning
start process (up to 10s after switching on)
Battery charge status 90­100%
Battery charge status 20­90%
Battery charge status <20%
error
no connection
Connection established
Pairing process
standby
input selected
Mute function activated
Maximum volume
true Wireless pairing process
stereo mode left channel
stereo mode right channel
Party mode

Troubleshooting

Here is an overview of the most common problems. if you have any further questions please contact your
Canton dealer, call our service Hotline on +49 (0) 6083 287­0 or send us an e­mail to info@canton.de.
Problem Possible cause
musicbox does not turn on. 1. Battery is fully discharged (e.g. after long
storage).
2. device temperature is lower than 0°C or higher
than 60°C. an internal protective circuit pre­
vents operation.
no sound reproduction. 1. no audio output from Mobile device.
2. Jack incorrectly connected or faulty (only in
auX operation).
3. the musicbox is set on mute (led flashes
white).
4. the protective circuit of the integrated amplifier
has been triggered (through overload or exces­
sive temperatures).
sound reproduction too soft. Volume of the musicbox or the mobile device set
too low. note: With some android devices and in
auX operation the volume between the musicbox
and the mobile device is not synchronised.
English
Solution
1. Charge the battery.
2. the musicbox should only be used at moderate
temperatures (see safety instructions, page 33)
1. Volume set to "Zero" (please refer to mobile
device instructions).
2. Check the connection between the mobile
device and the musicbox. Change the signal
cable if necessary.
3. increase the volume on the musicbox by pres­
sing vol+ button.
4. Reduce the volume and prevent the device from
overheating.
1. increase the volume on the musicbox using the
volume button "+".
2. increase the volume on the mobile device.
43