Table of Contents
Advertisement
FBB4 VARIABLE SPEED BLOWER INSTALLATION
JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS
CAUTION: All wiring should be done by a qualified elec-
trician and shall be in compliance with all local, city and state
building codes. Before making the electrical connection,
make sure that main power supply is disconnected. The
appliance, when installed, must be electrically grounded in
accordance with local codes or, in the absence of local
codes, with the national electrical code ANSI/NFPA 70 (latest
edition).
A factory installed junction box is located on the lower right side of
the fireplace. Wiring must be fed to the junction box and attached
to the receptacle that is provided. Leave approximately 6" of wire
in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached to
the green (ground) screw.
Install the receptacle into the junction box. Attach cover plate.
31453-6-0914
1
R7331
BLOWER MOTOR
2
31920
SWITCH ASSEMBLY
3
R4192
SPEED CONTROL KNOB
4
R4186
SPEED CONTROL
Figure 80
Page 75
Advertisement
Table of Contents
Troubleshooting
