To Install The Parallel Ieee 1284 Interface Board - Intermec EasyCoder PD41 Installation Instructions

Parallel ieee 1284 interface label printer

Hide thumbs Also See for EasyCoder PD41:

Table of Contents

Take precautions against electrostatic discharge, for

example by wearing grounded wrist straps.

To install the Parallel IEEE 1284 interface board

1 Turn off the printer and unplug the power cord..

2 Open the side door. Remove the two screws that hold the cover to the

electronics compartment.

3 Lay the printer down on its side, with the electronics compartment facing

up.

4 Loosen the electronics compartment cover by placing the tip of a slotted

screwdriver at the edge of the cover and gently pushing the handle

towards the top of the printer. DO NOT attempt to bend it loose.

Table of Contents

Do you have a question about the EasyCoder PD41 and is the answer not in the manual?

Easycoder pd42