Chauvet Rogue R2 Wash Quick Reference Manual page 3

Rogue™ R2 Wash QRG
AC Power
Power Linking
AC Plug
Replacing The
Fuse
DMX Linking
DMX Connection
This product has an auto-ranging power supply that can work with an input voltage
range of 100–240 VAC, 50/60 Hz.
To eliminate unnecessary wear and improve its lifespan, during periods of
non-use completely disconnect the product from power via breaker or by
unplugging it.
You can link up to 4 Rogue™ R2 Wash products at 120 V, 8 products at 208 V, or
9 products at 230 V. Never exceed this number. Power linking cords can be
purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1. Disconnect this product from power.
2. Using a flat head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
The Rogue™ R2
a 3- or 5-pin DMX serial connection. A DMX Primer is available from
www.chauvetprofessional.com.
The Rogue™ R2 Wash uses a 3- or 5-pin DMX data connection for its DMX
personalities: 15CH, 17CH, 22CH, 33CH, 33CH MS, 54CH MS, 54CH and
56CH. See the User Manual for information about connecting and configuring the
product for DMX operation.
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
Wash will work
3
Screw Color
Brown Yellow/Brass
Blue
with a DMX controller
EN
Silver
Green
using