Table of Contents
Advertisement
(2) Rewriting CWD Control Data
① Turn the printer ON.
② Run OP2-Tools, and select the printer for CWD control data rewriting.
③ Under the "Control Data" menu, click on "Write All data".
④ The file selection window will open. Select the CWD control data for rewriting, and click on the
"Open" button.
⑤ CWD control data transmission will begin, and the CWD control data rewriting will begin. When
rewriting the CWD control data, the green LED will blink.
⑥ When rewriting is complete, the LED will turn green. (It is not necessary to reboot the printer.
（Unlike when rewriting firmware, the printer does not beep when complete.）
⑦ Under the "Control Data" menu, click on "Version Check", then click on "Get".
Check that the rewritten CWD control data version and checksum are correct.
Finally, run a print to check that there are no problems.
If the print color is extremely light, it is possible that rewriting was not successful.
If the checksum is incorrect, the rewrite was not successful.
Run the rewrite again.
58
Advertisement
Table of Contents
