Table of Contents
Advertisement
Procedure 2. After adjusting the scrap length, measure the printed area length remaining in the scrap
nd
from the 2
print, and adjust the print position. Adjusting the print position will not affect the
cut scrap length.
Print result
Printed area in scrap
is less than 0.8mm
Printed area in scrap
is more than 0.8mm
Example：
0.80 ㎜ →Adjust 0.0 ㎜
0.30 ㎜ →Adjust－0.5 ㎜
1.30 ㎜ →Adjust＋0.5 ㎜
Scrap length 5.5 ㎜
Paper feed direction
④ Enter the value and click the "Setup" button. The setting will be written to the printer.
（The values set to the printer can be checked by clicking "Get" in the "Printer" menu.
⑤ Write the adjusted values on the Revision seal on the bottom inside the printer.
When replacing the Main Board
① Before replacing the Main Board, either write down the various setting values, or check the Revision
seal on the bottom inside the printer.
② Enter the values checked in ①.
Reason
Distance from sensor to head is
greater than the ideal value
Distance from sensor to head is
less than the ideal value
Set the Print position adjustment
→
subtracting the amount short
Set the Print position adjustment
→
adding the amount long
There is a Revision seal on the bottom
inside the printer, with setting value
when the printer left the factory. Write
the newly adjusted values on the seal.
53
Adjustment
Advertisement
Table of Contents
