03 Advanced user mode
Setting a destination
Selecting an address
03
Selecting a street address
Set destination
Address
The system will place the cursor on Street.
The most recently selected State and City will
be pre-selected.
40
1. To change the state or city, use the
navigation control to move to
City
and/or
,
2. Press ENTER, or choose among the most
recently chosen alternatives with
NOTE
The definition of a city or area may vary. It
will sometimes be an entire city, or a par-
ticular section of a city.
The system does not contain street
addresses for very small towns or villages.
In these cases, the center of the town is
used as the destination.
Alternative 1
•
Street
Select
without choosing a city.
The system will provide guidance to the mid-
point of the selected street. If the street exists
in more than one city, a list of alternatives will
be displayed.
Alternative 2
City
1. Begin by selecting a
.
Street
2. Select a
.
Selecting a street number
If the address selected has a street number,
this can be used as a specific destination.
1. After selecting a street, go to the
State
Number
row and press ENTER
or
Go directly to
.
bers will be displayed.
2. Go to
Set
after you have entered a street
number.
> If a street number has not been
entered, the system will guide you to
the mid-point of the selected street.
Set
Confirms the entered number.
Adjust
Returns to the previous screen.
Selecting an intersection
•
Interse.
Go to
intersects the selected street.
Start guidance
•
Set
Go to
to add the entered address to
the itinerary.
•
Go to
Start guidance
directions to the destination.
Information
Provides information about the destination.
Set
. Alternative street num-
and choose a street that
to begin receiving