Start Up The System - Cisco TelePresence MX700 Installation Manual
Hide thumbs
Also See for TelePresence MX700:
- Reference manual (241 pages) ,
- Administrator's manual (141 pages) ,
- Installation manual (32 pages)
Advertisement
Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
19
Start up the system
•
Remove the protection foil from the displays.
•
Make sure the camera can move freely.
•
Insert the network and power cables into the wall outlets.
•
Switch on the system.
The power switch is located directly below the codec, next to
the power connector.
Wait a few minutes while the system starts up. The start-up
may include automatic software upgrade and restart of
Touch 10 and camera.
•
Follow the instructions on Touch 10.
If your system is not set up to be automatically provisioned,
you must configure the system before you can make your
first call. This is described in the Getting Started Guide, which
can be found on the Cisco web site.
78-100218-01 A0 | 2014 APRIL | © 2014 Cisco Systems, Inc. All rights reserved.
Page 25
Advertisement
