Cisco TelePresence MX700 Installation Manual page 13

Installation guide for Cisco TelePresence MX700 Single camera - Floor stand
9
Fasten right monitor to floor stand and connect power cable
Connect the loose end of
2
the power cable from step 7
to the close-by socket at the
rear of the right monitor.
If the system is placed close
to the wall, you must reach
the socket from below.
Make sure the power switch
next to the socket is in its
ON position.
78-100218-01 A0 | 2014 APRIL | © 2014 Cisco Systems, Inc. All rights reserved.
4 × M6x90
(countersunk)
4 × M6x35
(countersunk)
Enter four screws from
1
front and four screws from
underneath. Then, tighten
all screws.
Page 13