Table of Contents
Advertisement
DCS 6000 Digital Conference System
Refer to Setup section for information in how to setup the system using the above menus.
Technical Specifications
System Specification
Digital Section
Sound quality ........... 20 bit audio @ 32 kHz sampling
frequency
Analog Section
Output signal type ground lifting transformer balanced
Nominal output level: ............ 0 dBm at nominal input
Max. Output level: ....................................... 15 dBm
Frequency response ................................. 125-15kHz
Signal to noise ratio: .................................>85 dBA
Total harmonic distortion: ........................... < 0.1%
General
Power requirement ................................. 24-48 V DC
Power consumption ............................ 2W maximum
Power supplied from
.................................. CU 61xx / EX 6010 / PS 6000
Temperature to guarantee specified performance
............. 5 Deg C. to 40 Deg C. (35 to 80% humidity)
Storage temperature
.......... -20 Deg C. to 60 Deg C. (10 to 80% humidity)
Weight ....................................................... 0.84 kg
Dimensions (W x H x D) ... 180 (205) x 38 x 120 (120)
mm
Dimensions in brackets are including brackets
Connectors
DCS-LAN loop through ......................... 2 pieces RJ45
Analog outputs connectors .. 4 - XLR3 male connectors
Remote Control commands in/out
By using SW 6000 control of the AO 6004 through the
CU 61XX is possible. A number of control messages are
used for this communication.
The CU 61xx can read the following info from the AO
6004:
By using SW 6000 the user can control the following
settings in the AO 6004 through the CU 6105/CU6110.
* ................ Channel number for each output channel
* ............................ Volume setting for each channel
The settings can only be read or controlled from SW
6000.
Specifications are subject to change without
notice.
11
User Manual
Advertisement
Table of Contents
