DCS 6000 Digital Conference System
Typical schematics
Connect the AO 6004 to the DCS 6000 network
using Cat 5 cables. The Analog Audio output
connectors are connected to either tape recorders
Using AO 6004 with DT 60xx Digital IR-Transmitter
When using the AO 6004 with the DT 60xx
Infrared Transmitter, the audio output level on the
AO 6004 has to be set to match the sensitivity on
the transmitter.
for recording the interpreted channels or to a DT
6008 Infrared Transmitter for transmitting the
interpreted channels wireless.
The correct level on each connected channel on
the AO 6004 is +3dB. This level is factory preset,
but can as earlier mentioned be changed using SW
6000. Please refer to the section 'Pre-configured
settings' on page 8. The DT 60XX input level
settings should be set to –6dB.
10
User Manual