Steam Delivery; Tips For Using Steam To Froth Milk; Clean The Steam/Hot Water Spout After Use; Memorising Your Personal Profile - DeLonghi ESAM6900 User Manual

The machine is now reprogrammed with the new quantity.
Please note!

Steam delivery

1. Check that the hot water spout is attached correctly.
2. Fill a container with the liquid to be heated or frothed and
immerse the steam spout in the liquid.
3 Press the icon (fig. 37). After a few seconds, the steam
to heat the liquid comes out of the cappuccino maker;
4. When the required temperature is obtained, interrupt
steam delivery by pressing the STOP icon. (You should
not discharge steam for more than 3 minutes at a time).
Important!
Always stop steam delivery before extracting the container
containing the liquid to avoid burns from splashes.

Tips for using steam to froth milk

the liquid doubles or triples in volume.
skimmed milk at refrigerator temperature (about 5°C).
movements in an upward direction.
clean the spout as described in the following section.

Clean the steam/hot water spout after use

Always clean the spout after use to avoid the build-up of milk
residues and prevent the spout from clogging.
1. Place a container under the cappuccino maker and deliver
a little water by pressing the
delivery of hot water by pressing the STOP icon again.
2. Wait a few minutes for the cappuccino maker to cool
down, then extract the hot water spout (fig. 38) by
pressing the button. Hold the spout with one hand and
with the other, turn the cappuccino maker and pull it
downwards (fig. 39).
3. Also remove the steam nozzle by pulling it downwards
(fig. 40).
4. Check the hole in the nozzle shown by the arrow in fig. 41
is not blocked. If necessary, clean using a toothpick.
5. Wash all parts of the spout thoroughly with a sponge and
warm water.
6. Insert the nozzle and cappuccino maker on the nozzle
by pushing it upwards and turning it clockwise until it is
attached.

MEMORISING YOUR PERSONAL PROFILE

EXIT PROG icon.
-
-
-
-
-
To use the function, proceed as follows:
1. Enter the "Profiles" section by pressing the
2. Choose your colour by pressing the CHANGE icon and
3. Proceed to programme the drinks which can be memorised
To change the profile, access profile selection by pressing the
icon at the bottom left corresponding to the colour in use:

CLEANING

icon (fig. 37). Stop

Cleaning the machine

The following parts of the machine must be cleaned regularly:
-
-
-
-
-
-
-
-
-
-
-
17
With this appliance, you can memorise six
different profiles, each associated with a
different colour.
In each profile you can customise:
the quantities of espresso and long "My coffee";
the quantities for all milk drinks;
the quantity of hot water;
the preferred background (from the menu);
the coffee temperature (from the menu).
then press the OK icon to confirm. The chosen colour
appears at the bottom left of the display to indicate you
are operating with that profile;
as described above. Each time you access the profile, the
machine uses the programmed settings.
Please note!
CHANGE icon to enter another profile and OK to
confirm;
icon to exit all profiles.
displayed to the right (for selecting background and
temperature).
coffee grounds container (A14),
drip tray (A9),
the inside of the machine, accessible after opening the
service door (A11),
water tank (A13),
coffee spouts (A7) and hot water nozzle (A6),
pre-ground coffee funnel (A3),
infuser (A12),
touch screen (B)
milk container (C)
hot chocolate carafe (D)
hot water/steam spout (E)
Important!
clean the appliance. With De'Longhi superautomatic
icon;