Toshiba 32L255 Series Owner's Manual page 22

Activating the picture preferences
You can customise current Picture Mode settings as
desired. For example, while selecting "Dynamic", if
you change the following items, such as Backlight,
Contrast, Brightness, Colour, Tint, Sharpness, and
the Picture Settings items, your new setting are
saved for "Dynamic" Picture Mode.
1
From the Picture Settings menu, press 
or  to select either Backlight, Contrast,
Brightness, Colour, Tint or Sharpness.
2
Press  or  to adjust the settings as desired.
Setting the Contrast Booster
Contrast Booster improves the defi nition of dark
areas of the picture.
1
From the Picture Settings menu, press  or 
to select Contrast Booster.
Picture Settings
Picture Mode
Backlight
Contrast
Brightness
Colour
Tint
Sharpness
Contrast Booster
2
Press  or  to select Middle, High, Off or
Low.
Using the Cinema Mode
This feature will reduce picture blur without
decreasing image brightness or adding fl icker.
1
From the Picture Settings menu, press  or 
to select Cinema Mode.
2
Press  or  to select On or Off .
Adjusting the Colour Temperature
Colour Temperature increases the warmth or
coolness of the picture by setting the red, green or
blue tint.
1
From the Picture Settings menu, press  or 
to select Colour Temperature, then press OK.
2
Press  or  to select Auto, Cool, Natural, or
Warm to suit your preference.
Colour Temperature
Colour Temperature
Red Level
Green Level
Blue Level
Reset
22
32405055L2550_EN.indd 22 32405055L2550_EN.indd 22
Using the TV's features
Standard
70
100
50
50
0
0
Middle
Cool
0
0
0
3
Press  or  to select Red Level, Green Level
or Blue Level, then press  or  to adjust the
setting as required.
Resetting the Colour Temperature
This function resets your colour temperature
settings to the factory settings.
1
From the Colour Temperature menu, press 
or  to select Reset, then press OK.
2
A confi rmation message will appear. Press  or
 to select Yes, and then press OK.
Activating the Noise Reduction (NR)
If the receiving signal of MPEG is a mosquito
(grained) noise depending on the compression and
conversion, the picture is weak and the picture is
blurry, the picture may be improved when using this
function.
1
From the Picture Settings menu, press  or 
to select Noise Reduction, and then press OK.
Noise Reduction
Auto Clean
MPEG NR
DNR
2
Select Auto Clean, and then press  or  to
select On or Off .
Off mode :
MPEG NR menu and DNR menu are available.
• MPEG NR mode: Low, Middle, High or Off
• DNR (Digital Noise Reduction) mode: Low,
Middle, High or Off
Resetting the Picture Settings
This feature resets the Picture Settings to the
factory settings.
NOTE:
If no picture settings have been changed, Reset is not
available.
1
From the Picture Settings menu, press  or 
to select Reset, and then press OK.
2
A confi rmation message will appear. Press  or
 to select Yes, and then press OK.
On
Auto
Auto
27/02/02 15:40:09 27/02/02 15:40:09