Changing An Option; Using Delay Wash; The Water Heating Signal Light; The Clean Signal Light - Whirlpool 8900 Series Use & Care Manual

2. Turn the Cycle Control Knob clockwise to the
cycle you want.
3. Be sure the detergent dispensers are filled
properly for the new cycle. When changing the
dial from LIGHT WASH or CHINA CRYSTAL to
POTS 8 PANS, HEAVY WASH or NORMAL
WASH setting, detergent is released. Reload
covered section of dispenser before starting
Pots 8 Pans, Heavy Wash or Normal Wash
Cycles.
4. Close and latch the door. The dishwasher will
automatically start the new cycle.
Changing an option
If you want to change a selected optlon. push the
RESET OPTIONS Button. Re-select an option,
if desired.
Using delay wash
You can set the dishwasher to start a cycle from
1 to 6 hours later.
1. Push desired Cycle Selector Button.
2. Push desired Option Selector Button(s).
3. Turn Cycle Control Knob clockwise to the
number of hours (from 1 to 6 hours) you want
the dishwasher to delay before the selected
cycle starts.
4. Close and latch the door. The DELAY
Signal Light will come on until the selected
cycle starts.
NOTE:
l
You can add items while time is counting down.
Close and latch the door. The timer will not
advance if the door is unlatched.
l
The Rinse & Hold, Light Wash and China Crystal
Cycles cannot be delayed.
The:water heating signal light
The WATER HEATING signal light will come on if
the dishwasher is heating the wash or rinse water.
Water is heated during parts of the Pots 8 Pans
Cycle. Water is also heated during parts of other
cycles when the Hi-Temp Rinse Option is selected
or the Lo-Energy Option is not selected (see
we 8).
The clean signal light