Changing A Cycle Setting; Changing An Option; Using Delay Wash; The Clean Signal Light - Whirlpool 8700 Series Use & Care Manual

Changing a cycle setting
You can change a setting anytime during any
cycle.
1. Lift up on the door latch to unlatch the door and
stop the cycle. Do not open the door until the
spray arms stop spinning.
2. Turn the Cycle Control Knob clockwise to the
cycle you want.
3. Be sure the detergent dispensers are filled
properly for the new cycle. When changing the
dial from LIGHT WASH to POTS&PANS,
HEAVY WASH or NORMAL WASH setting,
detergent is released. Reload covered section
of dispenser before starting Pots & Pans,
Heavy Wash or Normal Wash Cycles.
4. Close and latch the door. The dishwasher will
automatically start the new cycle.
selected cycle starts.
l
The DELAY/WATER HEATING Signal Light will
also come on while the water is heating during
all cycles.