Assembling Unifence Body To Guide Rail - Delta 36-475 Instruction Manual

ASSEMBLING UNIFENCE
B O D Y TO GUIDE RAIL
1 . Turn fence body (A) Fig. 65, upside down and lay it
o n a table or bench. Push handle (B) in against fence
body. Make certain the surface (C) of clamp bracket is
parallel to the face (D) of the fence body, and that the
inside edge (E) of the clamp bracket is pa r a l l e l t o s u r f a c e
( F ) of the fence body. Turn handle (B) Fig. 65, if neces-
sary.
2 . Place fence body (A) Fig. 66, onto the guide rail as
shown, making sure clamp bracket is inserted into chan-
nel (G) on rail. Notice that the clamp handle (B) is turned
t o t h e l e ft i n d e n t p o s i t i o n .
3 . Turn handle (B) Fig. 67, to the right indent position
as shown. This will prevent fence clamp from sliding out
of the channel (G).
4 . Lock fence body (A) to the guide rail by pushing
down on handle (B) as shown in Fig. 68.
B
D
A
22
E
F
C
A
Fig. 65
B
Fig. 66
B
Fig. 67
A
B
Fig. 68
G
G