Assembling Table Legs And Front Table Support - Delta 36-475 Instruction Manual

ASSEMBLING TA B L E L E G S AND FRONT TABLE SUPPORT
1 . The table board supplied will require thirteen 1/8†
diameter x 3/8†deep holes to be drilled in the bottom of
t h e table board at the locations illustrated in Fig. 45.
2 . Assemble ta b l e l e g ( A ) F i g . 4 6 , t o table board (B) using
f o u r # 8 x 7 / 8†long wood screws (C) as shown. Assemble
r emaining ta b l e l e g t o t h e table in the same manner.
CAUTION: D O N O T OVER-TIGHTEN L E G MOUNTING
S C R E W S. Over-tightening screws in particle board may
cause them to strip.
3 . Fasten front table support (D) Fig. 47, to the bottom
o f table using two 7/8†long wood screws (E) as shown.
CAUTION: D O N O T OVER-TIGHTEN S C R E W S (E).
Over-tightening screws in particle board may cause them
to strip. Do not completely tighten the two screws (E) at
this time, as adjustment is necessary.
Fig.45
D
E
17
A
B
C
Fig. 46
E
Fig. 47