Assembling Table Mounting Brackets To Saw Table - Delta 36-475 Instruction Manual

ASSEMBLING TABLE
MOUNTING BRACKETS
TO S AW TABLE
1 . Assemble Z-brackets ( A ) F i g . 4 0 , t o t h e t h r e e tapped
holes at the inside edge on the right side of saw ta b l e ( B ) ,
using three 7/16-20 x 3/4†hex head screws (C) with flat
washers and lockwashers.
2 . Using a square (D) Fig. 41, make certain the
Z-brackets ( A ) are perpendicular to the saw table as
shown. A l s o , l i ft upward on Z-brackets (A) while tighten-
ing screws (C) to eliminate any play.
3 . Fig. 42, illustrates the Z-brackets assembled to the
saw blade.
4 . Assemble angle bracket (E) Fig. 43, onto Z-bracket
( A ) using 1/4-20 x 3/4† carriage bolt (F) with flat washer
and hex nut. IMPORTA N T:The longer leg of angle
bracket (E) must be secured to Z-bracket (A). Assemble
the remaining two angle brackets to the edge of the table
in the same manner.
5 . Using a square (G) Fig. 44, set the angle brackets so
they are approximately 3/4†from the top of the saw ta b l e .
Final adjustments to angle brackets will be made later.
F
F
A
E
Fig. 43
C
A
16
B
Fig. 40
A
Fig. 41
Fig. 42
G
E
E
Fig. 44
D
A