Table of Contents
Advertisement
RPort Function
8.71. You can enable/disable the RPort in this page. To change this setting, please follow your ISP
information. When you finished the setting, please click the Submit button.
Other Settings
8.72. You can setup the Hold by RFC and QoS in this page. To change these settings please follows
your ITSP information. When you finished the setting, please click the Submit button. The QoS is
used to set the voice packet priority.
voice packets in Internet.
Internet devices.
l SIP Expire Time: 60 (15~86400 sec, 0=defined by Server).
l Keep Alives Period: 60 (Default: 60, Range: 15 ~ 250sec) that is send keepalives
messages in the RTP stream to keep NAT open.
l Jitter Buffer: 1 (Default: 1, Range: 0~250 packets)
l SIP Server Type: General, Asterisk, BroadWorks, Nortel, Xener, Vodtel.
l SIP VID: 0 (2~4094, 0: disabled). This VLAN ID is for SIP only through WAN.
l RTP VID: 0 (2~4094, 0: disabled). This VLAN ID is for RTP voice packets.
Higher value other than zero will get higher priority for the
However, the QoS function still needs to cooperate with the other
40
Advertisement
Table of Contents
