Fault Diagnosis; What To Do If - Electrolux „KITE“ Bar graph Variant Service Manual

5.

Fault diagnosis

5.1

What to do if ...?

Problem
The cooking zone cannot be
switched on or is not
functioning
Buzzer sounds when
appliance is switched off
The residual heat display
does not display anything
The buzzer sounds and the
appliance switches itself on
and off again after 5 sec.; the
buzzer sounds again after 5
sec.
"-" is illuminated
"E" and a number are
displayed
"?" is illuminated
DGS-TDS-N 12.07 U. H. / A. B. © Electrolux
Possible cause
More than 10 seconds have
passed since the appliance
was switched on
The child safety lock is
activated
Numerous sensor panels
were touched simultaneously
Automatic deactivation has
been triggered
There is water on the
operating panel or the
operating panel is covered
by fat splashes
Stop + Go is active
The operating panels
completely or partially
covered by objects.
There is water on the
operating panel or the
operating panel is covered
by fat splashes
The cooking zone has only
been on for a short time and
is therefore not hot yet
The On/Off sensor panel has
been covered up, e.g. by a
cloth
Automatic deactivation has
been triggered
Electronics error
Automatic deactivation has
been triggered
- 12 -
Remedy
Switch appliance back on
Deactivate the child safety
lock (see chapter "child
safety lock")
Only touch one sensor panel
Remove any objects (pot,
cloth, etc.) from the
operating panel, switch
appliance back on
Wipe over operating panel
Deactivate Stop + Go
Gegenstände entfernen
Wipe over operating panel
Contact customer service of
the cooking zone is hot
Do not place any objects on
the operating panel
Switch cooking zone off,
switch cooking zone back on
again
Disconnect the appliance
from the mains for a few
minutes (remove the fuse
from the house fuse cabinet).
if "E" isstill displayed after
switching back on, contact
customer service
Switch cooking zone off and
then back on again
599 531 461 EN