HP designjet cc800ps Assembly Instructions Manual

1 Plastic dust
cover
2 Scanner
3 Rear Table
4 Top bar
with guide
5 Leg (x2)
9 Cross bar
6 Maintenance
kit
7 Assembly
kit
8 Power
cables
Assembly poster
Your printer
should already be
assembled and working before starting this
procedure. For instructions on how to
assemble the printer, please refer to the
assembly poster included with the printer.
1
Attach the 2 feet
to the left and right
legs using 4
M6x30 screws (2
for each foot), tighten the screws with the Allen
key found in the assembly kit.
4
Attach the
bottom bar to
the leg using 2
M6X10 screws.
Assembly Instructions
hp designjet copier cc800ps
14 Front panel arm
12 Foot (x2) 13 Scanner
11 USB cables
10 Bottom bar
Read these instructions carefully...
and complete each stage before you start the
next.
What You Will Need to Do the Job
Because some of the components of the copier
are bulky, you will need 2 or 3 people to lift
them. See the descriptions that follow for
details, a symbol like this is used:
2
Secure the 2
legs by
fastening the cross
bar with 4 M6X10 screws (2 each side).
5
Attach the bottom bar to the other leg using 2
M6X10 screws.
18 System recovery
cd-rom
17 Media guides (x2)
Description
16 Front
panel
Screw M6X10 for base and top bar
15 Touch
screen
Screw M6X30 for base and top bar
stylus
Screw M4X25 for front panel arm
Allen Key 2,5mm for front panel
Screw M4X8 for front panel
maintenance
sheet
Slotted special screw for scanner
Allen Key 5mm for Top Bar
Allen Key front panel arm
3
Lay the 2 legs
down into the
position shown.
6
1
Assembly kit contents
A note about fixings:
When initially assembling the copier stand
do not fully tighten the screws; you will be
asked to do this later.
Raise the
legs carefully
into the
upright position.
Quantity
10
8
4
1
5
4
1
1