HP designjet cc800ps Assembly Instructions Manual page 3

21
Raise the two handles, and remove the
pressure platen.
24
Turn the pressure platen over to expose the
white background plate.
27
Dry the white background plate, rollers and
surrounding area fully using a separate clean,
dry lint-free cloth.
a
30 b
Pushing downwards on the right side of the
pressure platen; push in the pin (a) and slide in
the lock (b) locking the platen end into place.
32
Peel away the protective paper from the front
panel stylus (a) and stick to the side of the
front panel where shown (b).
Caution: see note after step 17
22
a
Clean the glass with a lint-free cloth and a mild,
streak-free, glass cleaner.
25
a
Clean the white background plate with a lint-
free cloth and a mild, streak-free, glass cleaner.
28
Replace the pressure platen and lower the two
handles.
31
With the platen firmly locked into place; close
the scanner cover.
33
a
b
Connect the front panel to the scanner using
the shorter USB cable and fastening with the
clips where shown (the clips are on the inside
of the arm).
23
Dry the glass fully using a separate clean, dry
lint-free cloth like the one provided with the
maintenance kit.
26
Clean the transport rollers and surrounding
area.
29
Pushing downwards on the left side of the
pressure platen; push in the pin (a) and slide in
the lock (b) locking the platen end into place.
34
Connect a power cable to the front panel and
a power outlet.
3
a b
a
b
Keep out dust and reduce maintenance
time...
Cover your scanner with the plastic dust
cover when not in use.
Caution: make sure the scanner
power is OFF when using the scanner
dust cover.