Led Indicators - Axis V5914 User Manual

AXIS V5914 PTZ Network Camera
Hardware Overview
The control button is used for:
• Resetting the product to factory default settings. See page 54.
• Connecting to an AXIS Video Hosting System service. See page 46. To connect, press and hold the button for about 3
seconds until the Status LED flashes green.
• Connecting to AXIS Internet Dynamic DNS Service. See page 46. To connect, press and hold the button for about 3 seconds.

LED Indicators

Status LED
Unlit
Green
Amber
Amber/Red
Red
Microphone power LED
Unlit
Blue
Note
• The tally LED can be configured to be lit or unlit during normal operation. To configure, go to Setup > System Options >
Ports & Devices > LED. See the online help for more information.
• The tally LED only indicates network transmission. If video or audio is only transmitted through HDMI or SDI the tally LED
will be unlit.
Tally LED
Unlit
Red
Indication
Connection and normal operation.
Shows steady green for 10 seconds for normal operation after startup completed.
Steady during startup. Flashes during firmware upgrade.
Flashes amber/red if network connection is unavailable or lost.
Flashes red for firmware upgrade failure.
Indication
Phantom power off.
Phantom power on.
Indication
Camera idle.
Active network transmission or recording.
9