Configure The Settings Relating To Images And Audio [Image/Audio]; Configure The Settings Relating To The Image Capture Mode [Jpeg/H.264] - Panasonic WV-SW559 Operating Instructions Manual

11 Configure the settings relating to images and audio [Image/Audio]

11 Configure the settings relating to images and
audio [Image/Audio]
The settings relating to JPEG and H.264 images such as the settings of image quality, audio, etc. can be
configured on this page.
The "Image/Audio" page has 3 tabs; the [JPEG/H.264] tab, the [Image quality] tab and the [Audio] tab.
11.1 Configure the settings relating to the image
capture mode [JPEG/H.264]
Click the [JPEG/H.264] tab on the "Image/Audio" page. (®page 46, page 48)
[Image capture mode]
Select an image capture mode from the following.
2 mega pixel [16:9]/1.3 mega pixel [16:9]/1.3 mega pixel [4:3]/3 mega pixel [4:3]
•
Default: 2 mega pixel [16:9]
IMPORTANT
•
The positions of areas may move out of alignment when the "Image capture mode" setting is changed
when the following area settings are configured. Therefore we recommend that you configure each
area setting after configuring the "Image capture mode".
–
mask area (®page 96)
–
privacy zone (®page 103)
–
VMD area (®page 120)
–
VIQS area (®page 105)
–
Cropping outlines (®page 132)
–
Picture in picture cropping area (®page 133)
Note
•
When "On" is selected for "VIQS" and the setting value for the aspect ratio is changed from "4:3" to
"16:9", make sure that the VIQS setting value does not exceed the maximum designated range.
•
When "3 mega pixel [4:3]" is selected, the following functions become unavailable.
–
"Pre alarm" for JPEG recording
–
"Image quality" for JPEG (the quality becomes "Quality1")
–
H.264(2)
–
"Alarm image attachment" for E-mail notification
–
"Alarm image FTP transmission" for alarm
–
"FTP periodic image transmission" for periodic FTP transmission
–
"Cropping"
–
"Picture in picture"
–
"Priority stream"
80 Operating Instructions