Montigo H38DF ST Installation & Maintenance Manual page 20

H*38DF ST Indoor Gas Fireplace
Installing the remote On/Off Wall Switch
The H*38DF*ST gas valve may be connected to a wall switch. Do
NOT connect any external power to the remote switch. The valve will
generate its own power on a millivolt circuit or will draw its power from
an AC Connection inside the fireplace, depending on the model of the
unit. Use only low voltage wire, and DO NOT connect any external
power to the remote switch.
Refer to Figure 17, 18, or 19 for wiring requirements.
NOTE: The switch location must not exceed 30' from the fireplace.
NOTE: If any of the original wire supplied with the appliance is replaced, it
must be replaced with the same type, or its equivalent.
Page 20
Installation
XG0207 - 150204.1