Table of Contents
Advertisement
4. Identify the slot into which the SIMM is to be installed—the
long slot with the two clips at the ends. Make sure that the
clips are open (leaning away from the slot).
Clips must be open.
w
c
20
Unpacking and Assembling the Printer
Warning:
Avoid touching the electrical components that are exposed
after you remove the side cover. These components may
become hot while the printer is in use.
Caution:
Before you install the module, be sure to discharge any static
electricity by touching a grounded piece of metal; otherwise,
you may damage static-sensitive components.
This is the slot.
Advertisement
Table of Contents
