Attaching The Console - Precor EFX 425 User Manual

Attaching the Console

Three cables attach to the console.
Figure 16: Cable attachments on back of console
Number Cable or feature
Base unit data cable
Console ground cable
Touch heart rate cable
To attach the cables to the console:
1. Ask your assistant to hold the console over the console bracket while you
carefully route the following console cables:
a. Insert the base unit data cable (1).
b. Insert the console ground cable (2).
c. Insert the touch heart rate cable (3) with the tabs pointing down.
Figure 17: Cable attachment
Assembling the Equipment
2. Set the console onto the console bracket. It should sit flush on the bracket
without gaps. If there is a gap, check to make sure that no wires are being
pinched.
Figure 18: Securing the display console
3. Secure the display console using four ¹₄-inch x ³₄-inch buttonhead screws.
Fully tighten the fasteners using the ⁵₃₂-inch hex key.
Fully Tighten the Remaining Fasteners
Return to the fasteners on the equipment frame that have been partially tightened
and fully tighten them.
To fully tighten the remaining fasteners:
1. Start at the base of the stabilizers and tighten all eight screws using a ¹₂-inch
socket with an extension.
2. If necessary, remove the wedge of packing material placed under the base
frame.
9