Replacing The Pre-Separation Pad - Kodak Scan Station 710 Administrator's Manual

Replacing the pre-
separation pad
A-61796 September 2014
1. Remove the separation module from the Scan Station by following
the steps previously described in "Replacing the separation module
and tires".
2. Hold the separation module in both hands and locate the two tabs
which protrude slightly from the back of the separation module.
3. Push down on the tabs until the pre-separation pad protrudes
slightly from the front of the separation module.
4. Grasp the pre-separation pad and pull it out of the separation
module.
5. Discard the worn pre-separation pad.
6. Align the side tabs of a new pre-separation pad with the slots on the
separation module.
7. Push the pre-separation pad firmly in the slots until the pre-
separation pad flap rests lightly against the separation module tires.
8. Reinstall the separation module by aligning the tabs with the slots
and snapping it into position.
10-9