Kodak Scan Station 710 Administrator's Manual page 25

3-8
• Updating — the configuration file or firmware is currently being
updated.
• In Use — when a USB flash drive is inserted, a user is logging in or is
interacting with the Scan Station, this state is displayed.
• Not found — the Scan Station cannot be found on the network (e.g.,
power is turned off).
Refresh Rate — allows you to set the amount of time that the
application will try and communicate with all Scan Stations.
HTTP Timeout — allows you to adjust the amount of time (in seconds)
that the HTTP commands have to complete. If some commands
timeout and do not complete, adjust this to a higher value.
HTTPS — turning HTTPS on will encrypt data as it is communicated
between the Kodak Scan Station 700 Series - Scanner Administration
application and the Scan Station.
Device — provides the following options. Procedures on how to use
these functions are described in Chapter 9, Monitoring and Managing
Your Scan Stations.
• Retrieve Logs: allows you to save the log files retrieved from the
selected Scan Station.
• Clear Logs: when selected, the following message will be displayed,
Are you sure you want to clear the log files of the selected
scanner? If you click Yes, the log files will be cleared.
• Retrieve Transaction Logs: allows you to save the transaction log
file retrieved from the selected Scan Station.
• Clear Transaction Logs: when selected, the following message will
be displayed, Are you sure you want to clear the transaction log
files of the selected scanner? If you click Yes, the transaction log
files will be cleared.
• Save All Logs: saves all available log files found on the selected
Scan Stations and saves them to the selected directory. The logs will
be saved in the selected directory under the Device Name folder of
the Scan Station.
A-61796 September 2014