Denon AVR-E200 Service Manual page 19

2.3. Clearing the protection history
There are two ways to clear the protection history, as described below.
(1) S tart up the set in error (protection display) mode and display the error, then press and hold down the "DIMMER"
button for 3 seconds.
FLD
P R T : D C
FLD
P R T : C L E A R
FLD
N O
(2) Initialize. ( 9 page.)
b If you want to save a backup, perform the method in 2.3.(1) above.
Warning indication by the POWER LED
If the power is turned off when a protection incident has been detected, the POWER LED (red) flashes as a warning
according to the conditions in which the protection incident occurred.
(1) ASO/DC/Power PROTECTION : Flashes at intervals of 0.5 seconds (0.25 seconds lit, 0.25 seconds off)
(2) THERMAL (A/B) PROTECTION : Flashes at intervals of 2 seconds (1 second lit, 1 second off)
Press the "DIMMER " button for 3 seconds.
The above is displayed and the protection history is cleared.
P R O T E C T
19