Prima MIG 210 SYNERGIC Operating Instructions Manual page 16

9 – Selector key of types of welding gas
Press this key to select the desired type of
welding gas:
CO - carbon dioxide
2
ArCO - Argon + carbon dioxide (mixture)
2
Ar - Argon
10–Overheating Yellow LED
it blinks when unit is overheating. The
thermostatic protection cuts off the
machine. Only the fan will keep on working
to cool the machine. The led automatically
extinguishes after the machine has cooled
suffi ciently.
11 –Enabled spool-gun Green led
it lights up when AL (aluminium) welding
wire is selected, automatically the enabled
torch will be the spool-gun.
12 -Green Led Synergic
It blinks when the generator is on synergic
mode. It extinguishes when manual mode
is set.
13 -Green Led Manual
It blinks when the generator is on manual
mode. It extinguishes when synergic mode
is set.
14 – Display
On synergic mode it views:
-the selected torch number 1-2-3
-torch-1- for iron and Inox welding
-torch-2-for CuSi welding
-torch-3-spool-gun, for aluminium welding. It is automaticaly selected when Al welding material is set.
-In "no welding" condition (no load), the display views two wordings: "Err" that means Error or "RDY" that means Ready.
By "RDY" display the unit is ready for welding; by "Err" display unit doesn't work, set welding parameters are not correct.
-The display views the real welding current. After welding the display will view the welding current value for a maximum of 5 seconds.
The display on manual mode views:
-the wire speed
-pulsation time in pulsed mode
-the selected torch
-the wording READY is always displayed in manual mode, as all settings are possible. The correct setting is up to the welder experience
-The display views the real welding current. After welding the display will view the welding current value for a maximum of 5 seconds.
15– EURO -1- connection
for iron/Inox welding torches.
16– EURO –2- connection
for CuSi welding torches.
17 – Choke socket (H = High Inductance)
18 - 7 pole connector for spool-gun
19 – Connector for spool-gun
20 – Gas connectior for spool-gun
21 – Supply cable
22 – Mixture gas (Argon-C02) hose
23 – Argon gas hose
24 – Cylinder fi xing clamp
It is made to accept either the classic cilinder ø 220 or 2 ø 160
cylinders at the same time. To change the cylinder model, remove
it, turn it and replace it again.
25 - Torch holder tube (see fi g. 4 to assemble it)
16
11
5
-R
4
13
FIG. 4
14
10
6
25
20 19
18
7
8
9
12
FIG. 3