Fibre Channel Interface - HP XP7 Configuration Manual

HP XP7 Array Manager Software
Check with your HP representative for other XP7 software available for your system.
NOTE:
Linux, NonStop, and Novell NetWare: Make sure you have superuser (root) access.
OpenVMS firmware version: Alpha System firmware version 5.6 or later for Fibre Channel
support. Integrity servers have no minimum firmware version requirement.
HP does not support using Command View Advanced Edition Suite Software from a Guest
OS.
In addition, for Solaris, ensure the following requirements are aslo met before installing the disk
array:
Volume Manager: Solaris Volume Manager or Veritas Volume Manager.
Oracle SAN software: For Solaris 8/9 (if not using Emulex, QLogic, or JNI drivers), latest SAN
Foundation Software with current patches. For Solaris 10 (if not using Emulex, or QLogic
drivers), latest SAN (Leadville driver stack) with current patches.
Oracle StorEdge Traffic Manager/Oracle VM Storage Multipathing requires that you configure
/kernel/drv/scsi_vhci.conf.
For Solaris 8/9 SAN information, see Oracle StorEdge SAN Foundation Software & Installation
Guide and Oracle StorEdge Traffic Manager Software Installation and Configuration Guide
at www.oracle.com.
For Solaris 10 and later SAN information, see Solaris Fibre Channel and Storage Multipathing
Administration Guide at www.oracle.com.

Fibre Channel interface

The XP7 family of disk arrays support the following Fibre Channel elements:
Connection speeds of 2 Gbps, 4 Gbps, and 8 Gbps.
Short-wave non-OFC (open fibre control) optical interface
Multimode optical cables with SC or LC connectors
Public or private arbitrated loop (FC-AL) or direct fabric attach
Fibre Channel switches
Even though the interface is Fibre Channel, this guide uses the term "SCSI disk" because disk array
devices are defined to the host as SCSI disks.
Fibre Channel elements specific to NonStop:
Connection speeds of 1 Gbps, 2 Gbps, and 4 Gbps
Short-wave non-OFC (open fiber control) optical interface
Multimode optical cables with LC connectors
Direct connect (PriNL) or fabric switch connect (N-port or DFA)
Fibre Channel switches
Fibre Channel interface 9