HP XP7 Configuration Manual page 25

To set up and verify the auto-mount parameters:
1. Edit the /etc/checklist (/etc/fstab) file to add a line for each OPEN-x device on the
disk array. This example and the following table show the auto-mount parameters.
Example
#cp -ip /etc/checklist /etc/checklist.standard
#vi /etc/checklist
/dev/vg00/lvol1
/dev/vg00/lvol2
:
/dev/vg06/lvol1
/dev/vg06/lvol2
P1
Table 4 Auto-mount parameters (HP-UX)
Parameter Name
P1 Device to mount
P2 Mount point
P3 File system
P4 Mount options
P5 Enhance
P6 File system check (fsck pass)
P7 Comments
2. Reboot the system.
3. Use the bdf command to verify the file system again.
/ hfs
swap ignore rw
/AHPMD-LU00 hfs
/AHPMD-LU01 hfs
P2 P3
rw 0 1 # root
0 0 # primary swap
defaults 0 2 # AHPMD-LU00
defaults 0 2 # AHPMD-LU01
P4 P5 P6 P7
Enter
Block-type device file name
Mount directory name
Type of file system (for example, hfs, vxfs)
"defaults" or other appropriate mount options
0
Order for performing file system checks
Comment statement
Configuring disk array devices 25