Table of Contents
Advertisement
Feature lighting
The selected brightness is saved for
both zones. The temperature reappears
in the display.
When the appliance door is closed, the
set brightness takes effect. When the
appliance door is opened, the interior
lighting returns to its normal level.
Lighting duration of the feature
lighting
The lighting duration for the feature
lighting is set to 30 minutes at the
factory.
The lighting duration can be set to 30,
60, 90 minutes, up to 00 (unlimited).
The feature lighting will have the
brightness setting you have selected
previously.
^ Open the appliance door.
^ Tap the On/Off sensor button for the
feature lighting so that it is
highlighted in yellow.
^ Tap the sensor button for the feature
light again (about four seconds long),
until ^ flashes in the display.
^ Use the X and Y sensor buttons for
altering the temperature to set the
feature lighting duration.
The duration (in minutes) will flash in
the display.
28
By touching the button:
– lighting duration is reduced by 30
minutes
– lighting duration is increased by 30
minutes
^ Tap the OK button to confirm your
choice.
The selected lighting duration is saved
for both zones. The temperature
reappears in the display.
The lighting duration set starts anew
whenever the appliance door is opened
and closed.
Do not remove the lighting covers.
Should the covers be damaged or
need to be removed due to
damage, use caution. There are
lasers in the lighting (laser beam
class 1M) which you should avoid
looking at directly. Do not use
optical instruments (magnifying
glass or similar) to look at the
lighting.
Advertisement
Table of Contents
