ATTENTION! This Honeywell Executive Safe includes a new Dual User Code Digital Lock. This update replaces the User Code Programming Instructions located on Page 3 of the Owner’s Manual for Executive Safe Models 3014D, 3018D, 3024D, 3032D, 3114D, 3118D, 3124D, 3132D, 3310D, 3330D, 3350D, 3410D, 3430D, &...
PRIMARY & SECONDARY USER CODES Your new safe is equipped with a digital lock that can be operated with two separate user codes. You will need to program these user codes with your own 3-8 digit user codes. It is recommended that you record your new user codes and keep in a secure location away from the safe.
SECONDARY USER CODE PROGRAM THE SECONDARY USER CODE Once you have successfully programmed the Primary user code, you can proceed to programming the Secondary user code. The Secondary user code is programmed using the Digital Keypad and it is not necessary to open the safe to proceed. 1.
LOST OR FORGOTTEN USER CODES LOSS OF PRIMARY USER CODE If the 3-8 digit Primary user code is lost or forgotten you can enter a new 3-8 digit Primary user code by opening the safe with the 3-8 digit secondary user code and using red reset button located on the inside edge of the door.
Models 3310D, 3330D, 3350D 3410D, 3430D & 3450D EXECUTIVE /JEWELRY SAFE WITH PROGRAMMABLE DIGITAL LOCK Read this manual carefully and never store it inside the safe!
SAFE SERIAL NUMBER Whenever contacting our Consumer Assistance Department, you will need to provide them with the serial number of your safe. Your safe’s serial number is on a tag that is located on the front of the safe in the lower right corner. IMPORTANT: Do Not Remove Safe I.D.
UNLOCK & OPEN YOUR NEW SAFE DOOR HANDLE The handle spindles have been shipped inside the Styrofoam cover on the outside of the safe door and should be installed before opening safe the first time. UNLOCK AND OPEN THE SAFE 1.
REPLACING BATTERIES IN LOCK NOTE: The pass code will not be erased if the batteries become weak or are removed. Dead or weak batteries should always be removed promptly. If your batteries are dead and you cannot open the safe by using the digital keypad, you must use the override access key (see below) to open safe and access the battery compartment.
APPROPRIATE USE This Executive Safe protects records and many other valuables. Testing shows that the interior temperature of the safe remains below 350°F (177°C) for 30 minutes during a fire up to 1400°F (760°C) when used properly. Your safe must be closed and latched in order to properly protect the contents from fire.
ANCHORING YOUR SAFE You may bolt the safe to the floor to increase protection from theft and resistance to tipping. This safe was manufactured with bolt down hole(s) pre-drilled in the floor panel. To secure your safe to the floor: 1.
INSTALLING SHELVES Note: Quantity of included shelves and gun racks will vary depending on the model 1. Remove shelf, gun rack and shelf support clips from protective wrapping. 2. Determine the desired location of your shelf and/or gun rack and note the corresponding support guide slots on the vertical standards that are best suited to support the shelf in that location.
LIMITED WARRANTY LH Licensed Products, Inc., (“LHLP, Inc.”) warrants that for a period of seven (7) years from the date of purchase, this product will be free from structural or mechanical defects resulting from materials or workmanship. LHLP, Inc., at its sole option and as the purchaser’s sole remedy under this warranty, will repair or replace this product or any component of the product found to be defective during the warranty period.
Manufactured by LH Licensed Products, Inc. 860 East Sandhill Avenue Carson, CA 90746 The Honeywell Trademark is used under license from Honeywell International Inc. Honeywell International Inc. makes no representations or warranties with respect to this product. M3310DE20150730...