Primary User Code - Honeywell 3014D Owner's Manual

PRIMARY & SECONDARY USER CODES
Your new safe is equipped with a digital lock that can be operated with two separate user
codes. You will need to program these user codes with your own 3-8 digit user codes. It is
recommended that you record your new user codes and keep in a secure location away
from the safe. You must program the Primary user code first. After the Primary user code
is programmed and tested you can then proceed to program the Secondary user code.

PRIMARY USER CODE

UNLOCK AND OPEN SAFE
IMPORTANT: Always make sure that the spindle handle is turned counterclockwise to the
left before entering user code.
1. Open your new safe by entering 1-2-3-4-5-6 followed by the # key on the keypad.
2. After user code is entered, the keypad will beep once and the green LED will light up.
3. Turn the spindle handle to the right (clockwise) to open.
NOTE: You must open the safe within 5 seconds or the safe will relock.
PROGRAM THE PRIMARY USER CODE
1. With door open, locate and press the red reset button
located on the inside edge of the door (see illustration), the
keypad will beep twice and the green LED will light up.
2. Enter a new 3-8 digit Primary user code followed by the #
key. The green LED will light up and the keypad will beep.
3. Immediately re-enter the new 3-8 digit user code a second
time followed by the # key and the green LED will flash
twice and the keypad will beep twice.
4. This new Primary user code is now active.
TEST THE PRIMARY USER CODE
1. With door open, rotate handle counterclockwise to put door bolts in lock position.
2. Enter the new 3-8 digit Primary user code followed by the # key. The green LED will
light up and the keypad will beep.
3. Rotate the spindle handle clockwise within 5 seconds.
4. The lock bolts should recede into the unlocked position when the handle is turned.
REPROGRAM A NEW PRIMARY USER CODE
In the future, this user code can always be changed by opening the safe and using the
reset button.
1. Once the safe door is open, locate and press the small reset button located on the
inside edge of the door, the keypad will beep twice and the green LED will light up.
2. Enter a new 3-8 digit Primary user code followed by the # key, the green LED will
again light up and the keypad will beep.
3. Immediately re-enter the new 3-8 digit user code a second time followed by the # key
and the green LED with flash twice and the keypad will beep twice.
4. This new Primary user code is now active and the old Primary user code is deleted.
1