Table of Contents
Advertisement
TAPE REMOVAL METHOD AT NO POWER SUPPLY
1.
Remove the TV/DVD/VCR block from the main unit and the Fig. 1 below can be seen.
(Refer to item 1 of the DISASSEMBLY INSTRUCTIONS.)
Remove the screw 1 of the Deck Chassis and remove the Loading Motor.
2.
3.
Rotate the Pinch Roller Cam in the direction of the arrow by hand to slacken the Video Tape.
(Refer to Fig. 2)
4.
Rotate the Clutch Ass'y either of the directions to wind the Video Tape in the Cassette Case.
5.
Repeat the above step 3~4. Then take out the Video Cassette from the Deck Chassis. Be careful not to
scratch on the tape.
Fig. 1
DISC REMOVAL METHOD AT NO POWER SUPPLY
1.
Remove the Back Cabinet and TV//DVD/VCR Block. (Refer to item 1 of the DISASSEMBLY
INSTRUCTIONS.)
2.
Rotate the Main Gear in the direction of the arrow by hand.
(Refer to Fig. 1)
3.
Draw the Tray.
Loading Motor
Screw 1
Pinch Roller Cam
Main Cam
Main Gear
Fig. 1
A1-7
Main Chassis (Front Side)
Fig. 2
DVD Deck
Capstan DD Unit
Clutch Ass'y
Advertisement
Table of Contents
