Light Bulb Replacement; Headlight Bulb Replacement; Taillight Bulb Replacement; Wheels And Tires - Bad Boy Ambush iS Owner's Manual

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry

Headlight Bulb Replacement

Make sure that the vehicle key switch is in the OFF position
and the key has been removed.
Locate the headlight bulb socket on the backside of the light
assembly. Turn bulb socket a quarter turn counterclockwise to
unlock. Pull out bulb and socket, remove old bulb from the
socket. Insert new bulb in socket and position bulb socket into
headlight housing and rotate socket a quarter turn clockwise
to secure.

Taillight Bulb Replacement

Make sure that the vehicle key switch is in the OFF position
and the key has been removed.
The taillight contains an LED light board rather than a light
bulb, if the LEDs burn out the whole light will have to be
replaced.

WHEELS AND TIRES

A tire explosion can cause severe injury or death. Never exceed the inflation pressure rating on
To reduce the possibility of tire explosion, pressurize tire with small amounts of air applied inter-
mittently to seat beads. Due to the low volume of the small tires, over inflation can occur in sec-
onds. Never exceed the tire manufacturer's recommendation when seating a bead. Protect face
Use caution when inflating tires. Over inflation could cause the tire to separate from the wheel or
cause the tire to explode, either of which could cause severe injury.
To reduce the possibility of severe injury caused by a broken socket when removing wheels, use

Tire Repair

Tool List
Lug Wrench, 3/4" or 17mm.......................................... 1
Impact Wrench ............................................................ 1
Steel wheel rims will require the 3/4" lug wrench and aluminum wheel rims will require the 17mm lug wrench.
Generally, the most cost effective way to repair a flat tire resulting from a puncture in the tread portion is to use a com-
mercial tire plug.
tissue or paper towel to handle the glass portion of the bulb.
the tire sidewall.
and eyes from escaping air when removing a valve core.
only sockets designed for impact wrench use.
Inside
of Cowl
Qty. Tool List
Impact Socket, 3/4" or 17mm ...................................... 1
Torque Wrench, ft. lbs. ................................................ 1
Owner's Manual
MAINTENANCE
Headlight
Bulb
B
Qty.
33