Unidirectional Tires; Light Bulb Replacement; Headlight And Front Turn Signal; Tail Light/Brake Light - Bad Boy AMBUSH Owner's Manual

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

Unidirectional Tires

Unidirectional tires may be identified by a directional arrow on the sidewall. Be sure to position the wheel on the hub cor-
rectly with the arrow indicating the direction of rotation when moving forward.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry tissue or
paper towel to handle the glass portion of the bulb.

Headlight and Front Turn Signal

For vehicles equipped with lights mounted in the cowl, locate
bulb socket on backside of light and turn bulb socket a quarter
turn counterclockwise to unlock and pull out bulb and socket.
Insert new bulb and rotate socket a quarter turn clockwise to
5
secure.
Similarly replace the turn signal light bulb, locate bulb socket
on backside of light bar and turn bulb socket a quarter turn
counterclockwise to unlock and pull out bulb and socket.
Insert new bulb and rotate socket a quarter turn clockwise to
secure.

Tail Light/Brake Light

To replace the tail and brake light bulb, roll the rubber bezel
from around the edge of the taillight and remove lens. Install
replacement bulb and replace lens.

BRAKES

This vehicle is equipped with four wheel hydraulic brakes; rear drum brakes and front disc brakes, the parking brake is
hand operated. Check the fluid level at intervals specified in the PERIODIC SERVICE SCHEDULE; if fluid leaks are
noticed or the brake pedal seems soft check the fluid level immediately.

Master Cylinder

The master cylinder is located under the front of the vehicle, the reservoir is located behind
the instrument panel in the dash. To access the master cylinder reservoir remove three
phillips head screws securing the instrument panel in place, tilt the panel forward and
down. Before removing either reservoir cap, clean any dirt or debris from around the reser-
voir and caps.
Check fluid level in both reservoir sections, the fluid level should be between the MAX and
MIN lines.
Page 5 - 6
Roll Rubber Bezel
Away From Bracket
Brake/Tail Light
Inside
of Cowl
Headlight
Bulb