Routine Maintenance; Lifting The Vehicle - Bad Boy Ambush iS Owner's Manual

Hide thumbs Also See for Ambush iS:
Table of Contents

Advertisement

MAINTENANCE
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

ROUTINE MAINTENANCE

Preventive maintenance, applied at recommended intervals, is the best guarantee for keeping the vehicle dependable.
This vehicle will give years of satisfactory service, providing it receives regular maintenance. Refer to the PERIODIC
SERVICE SCHEDULE for appropriate service intervals.

LIFTING THE VEHICLE

Tool List
Floor Jack.................................................................... 1
Jack Stands................................................................. 4
Wheel Chocks ............................................................. 4
To reduce the possibility of severe injury or death
from a vehicle falling from a jack:
Always place chocks in front and behind the
wheels not being raised.
Be sure the vehicle is on a firm and level surface.
Never get under a vehicle while it is supported by
Use jack stands and test the stability of the vehi-
cle on the stands.
Use extreme care since the vehicle is extremely
unstable during the lifting process.
When lifting the vehicle, position the jacks and jack
stands at the areas indicated.
Remove payload from vehicle before lifting. No person(s) should be in or on the vehicle
while lifting.
To raise the entire vehicle, install the wheel chocks in front and behind each front wheel.
Center the jack under the rear axle tube next to differential housing or under the skid
plate. Raise the vehicle and position the jack stands under the frame where the leaf
spring mounting bracket is welded to the frame.
Lower the jack and test the stability of the vehicle on the two jack stands.
Place the jack under the center front of the car just behind the bumper. Raise the vehicle
and position the jack stands under the frame where the instrument panel support is
attached to the frame.
Lower the jack and test the stability of the vehicle on all four jack stands. To raise only
the front or rear of the vehicle, place the wheel chocks in front and behind the wheels that are not to be raised. The jack
may be left under the center front of the frame while the front end of the vehicle is on the jack stands.
Lower the vehicle by reversing the lifting sequence.
32
a jack.
Qty
Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents