Maintenance; Vehicle Cleaning And Care; Transporting Vehicle - Bad Boy Ambush iS Owner's Manual

Hide thumbs Also See for Ambush iS:
Table of Contents

Advertisement

MAINTENANCE

Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
MAINTENANCE

VEHICLE CLEANING AND CARE

To reduce the possibility of severe injury or vehicle damage, read and understand all instructions
supplied by manufacturer of pressure washer.
When pressure washing exterior of vehicle, do not use pressure in excess of 700 psi and maintain a 12" mini-
mum distance from spray nozzle to painted surface. To reduce the possibility of cosmetic damage, do not use
any abrasive or reactive solvents to clean plastic parts.
It is important that proper techniques and cleaning materials be used. Using excessive water pressure may cause severe
injury to operator or bystander, damage to seals, plastics, seat material, body finish or electrical system. Do not use pres-
sure in excess of 700 psi to wash exterior of vehicle.
Clean windshield with lots of water and a clean cloth. Minor scratches may be removed using a commercial plastic polish
®
or Plexus
plastic cleaner available from the service parts department.
Normal cleaning of vinyl seats and plastic or rubber trim requires the use of a mild soap solution applied with a sponge or
soft brush and wipe with a damp cloth.
Removal of oil, tar, asphalt, shoe polish, etc. will require the use of a commercially available vinyl/rubber cleaner.
The painted surfaces of the vehicle provide attractive appearance and durable protection. Frequent washing with luke-
warm or cold water and mild detergent is required to preserve the painted surfaces.
Occasional cleaning and waxing with non-abrasive products designed for 'clear coat' automotive finishes will enhance
the appearance and durability of the painted surfaces.
Corrosive materials used as fertilizers or for dust control can collect on the underbody of the vehicle. These materials will
cause corrosion of underbody parts unless flushed occasionally with plain water. Thoroughly clean any areas where mud
or other debris can collect. Sediment packed in closed areas should be loosened to ease it's removal, taking care not to
chip or otherwise damage paint.

TRANSPORTING VEHICLE

Be sure vehicle and all contents are secure before transporting a vehicle.
Never ride on the vehicle being transported.
Always remove windshield (if equipped) before transporting.
Maximum speed with sun top installed is 70mph (112 kph).
If the vehicle is to be transported at highway speeds, the windshield must be removed and the seat bottom secured.
When transporting vehicle below highway speeds, check for tightness of hardware and cracks in sun top at mounting
points.
The rated capacity of the trailer or truck must exceed the weight of the vehicle (see GENERAL SPECIFICATIONS for
vehicle weight) and load plus 1000 lbs. (454 kg).
Secure the vehicle using ratchet tie downs.
31
Owner's Manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents