Head Light Switch; Turn Signal Light Switch - Bad Boy 550cc Owner's Manual

Bench seat
① Seat belt
Bucket seat
① Seat belt
2. Selecting light switch position.
■ Head Lights Switch
Turn on the key switch and toggle the head
light switch to the "ON" position.
Toggle the head light switch to the "OFF"
position to turn off the head light.
Operating the Vehicle
8-2

① Head light switch

② Head lights "OFF"
③ High beam lights "ON"
④ Low beam lights "ON"
⑤ 4WD button
⑥ 2WD button
⑦ Front axle differential lock
⑧ Front axle differential unlock
⑨ Emergency light "ON"
⑩ Emergency light "OFF"
⑪ Winch cable release
⑫ Winch cable pulled up
⑬ Left turning lights
⑭ Right turning lights
⑮ Accessory switch
⑯ Blank switch cut-out
NOTE：
Turning the head light switch to the "ON"
position causes the following lamps to light
simultaneously.
1. Tail lights (lamps at the rear portions of the
vehicle)
2. Lamp built in the coolant temperature
gauge
3. Lamp built in the fuel gauge
4. Lamp built in the speedometer
5. Front left and right position lights
■ Hazard Light Switch
Press the hazard switch to the up position to
turn on the hazard lights. This will turn on the
blinking turn signals and audible alarm will
sound.
Note:
The hazard light switch will operate when
the key switch is in the "ON" position. Be
careful that keeping the switch "ON"
causes the battery to run out.

■ Turn Signal Light Switch

[if equipped]
To indicate a right turn, push on the lower
half of