Table of Contents
Advertisement
CONTENTS OF PACKAGE
Installation of the camera must be performed by qualified service personnel in
accordance with all local and national electrical and mechanical codes.
Carefully remove the colour camera and its accessories from the carton and
verify that they were not damaged in shipment.
The content of the package includes:
1. Camera
3. Instruction manual
5. DC Jack
BASIC INSTALLATION
CAUTION: When installing the camera outdoors, the following instructions must
be followed closely.
1. Loosen the four Torx screws on the housing cover. Do NOT remove the screws
from the cover.
2. Use the mounting template as a drilling guide to ensure correct positioning of the
screws.
3. Drill 4 holes into the mounting template. Insert the screw raw plugs (anchors) and
attach the housing using the 4 x M6 Torx screws.
NOTES:
If the 2.1mm jack adaptor is not used then please ensure the
correct polarity is observed when 12VDC is being used. The
terminals are colour coded to assist: Red = 12VDC / Black = 0V
If using the UTP (U) models, please note that you cannot use the
BNC output at the same time.
If the camera is being installed externally, please ensure the side
¾" NPT thread is sealed with Teflon tape or suitable sealant.
There are 2 photocells on the LED array in DNLED models and the
cap is pre-fitted to one of these. To reduce any hunting effect,
please place the cover over the photocell that is closer to being
angled/located inside the housing.
2. Fixings
4. Template sheet
8
Advertisement
Table of Contents
