Panasonic DMR-BCT855 Operating Instructions Manual page 105

Displays
"0:00" is flashing on the front panel display.
• Set the clock. ( 97)
The clock does not display on the unit when
switched to standby.
• The clock does not display when "Front Panel
Display" is set to "Automatic". (
TV screen and video
Screen size is wrong.
• Check the "TV Aspect" or "Aspect for 4:3 Video".
( 93)
• Adjust the aspect ratio setting on TV.
• Adjust the aspect ratio setting on this unit.
( 103)
• Check "Aspect for Recording" before recording
or file conversion. (
[BCT855] [BCT850] [BCT755] [BCT750]
TV reception is not displayed.
• Broadcast signals are not output from this unit's
RF OUT terminal. Select "On" in "RF OUT
( CATV Signal )" or "RF OUT ( Aerial Signal )".
( 97)
The black screen appears on the TV.
• This phenomenon may occur, depending on the
TV setting, when "Quick Start" is activated.
Depending on the TV, this phenomenon may be
prevented by reconnecting to a different HDMI
input terminal.
The screen changes automatically.
• If "Screen Saver" is set to "On", the screen saver
function will be activated when there is no
operation for 5 minutes or more. (
92)
90)
92)
There is a lot of image lag when playing video.
• Set to "0" all items in the "Noise Reduction".
( 84)
• Set "Audio Delay". (
The images do not appear on the TV.
The picture is distorted during play, or video
is not played correctly.
• Check the connections. (
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in "HDMI
Video Format". ( 93) Reset the setting as
follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• "00 RET" is displayed on the front panel
display.
2 Repeatedly press [1] (right) until "04 PRG"
is displayed on the front panel display.
3 Press and hold [OK] for at least 3 seconds.
Set the item again.
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output
®
properly, select "Yes" in "Default Settings"
and make proper settings. (
• The unit's TV System is different from that of the
disc. Change the TV System. (
System)
• The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
• Set "Deep Colour Output" (
Type Flag" ( 94) to "Off".
3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- "3D Type" of "3D Settings" (
- "Signal Format" (
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. ( 18)
• When "HDMI Audio Output" is set to "Off", 3D
video may not be output correctly. (
Troubleshooting
92)
16, 17)
98)
93, TV
93) or "Contents
93)
52, 3D settings during
93)
105
SQT0807