Panasonic DMR-BCT855 Operating Instructions Manual page 107

[BCT855] [BCT850] [BST855] [BST850]
Cannot record two programmes
simultaneously.
• When "DVB-via-IP Server" is set to "On", this unit uses one
tuner. As a result, the maximum number of programmes
that can be simultaneously recorded with this unit is
reduced by one. Set "DVB-via-IP Server" to "Off". (
Play
Cannot play back.
• The disc is dirty. ( 10)
• The disc is scratched or marked.
• The disc may not be able to play back if it was
not finalised or a Top Menu was not created on
the equipment used for recording.
• Refer to "Screen icons". (
• Depending on the encrypted service, it may not
be possible to play back certain titles if they
have been recorded without being decrypted.
Audio and video momentarily pause.
• DVD-R DL and +R DL discs have two writable
layers on one side. Video and audio may
momentarily cut out when the unit is switching
layers.
You have forgotten your rating PIN.
• The rating level returns to the factory preset.
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• "00 RET" is displayed on the front panel
display.
2 Repeatedly press [1] (right) until "03 VL" is
displayed on the front panel display.
3 Press [OK].
• "Init" is displayed on the front panel display.
Image for the Quick View is not smooth.
• Image may not be played back smoothly in case
of high definition titles.
Cannot play the disc on other players.
• Refer to "Play on other players". (
76)
44)
10)
Edit
Cannot edit.
• You may not be able to edit on the HDD if there
is no available space. Delete any unwanted
titles to create empty space. (
Photo
The contents of the SD card cannot be read.
• Remove the card from the slot and then insert
again. If this does not solve the problem, switch
the unit to standby mode and turn it on again.
Photos do not play back normally.
• The images that were edited on the PC, such as
Progressive JPEG, etc., may not play back.
( 8)
USB
This unit does not recognize the USB device
correctly.
• If inserted during playback the USB device may
not be recognized by this unit.
Disconnect and reconnect the USB device. If it
still does not recognize the connection, switch
the unit to standby mode and turn it on again.
• USB devices connected using a USB extension
cable other than a dedicated one or a USB hub
may not be recognized by this unit.
TV Guide
The TV Guide information is not displayed
properly.
• Set the clock correctly. (
• There was a programme change, or TV Guide
information from a broadcast station was
possibly not correctly transmitted.
• If signal quality is bad, the TV Guide system
may not be able to receive any data.
• It may take time until the TV Guide screen is
displayed correctly. Wait for about a day.
Troubleshooting
53)
97, Clock)
107
SQT0807