Table of Contents
Advertisement
Items Included With Your Model:
Transmitter
AA batteries (4)
Assembled aircraft
Li-Po battery
USB charge lead
Charging the Flight Battery
Open the door on the transmitter to access the
charger lead or plug the USB charge lead into a
computer USB port. Connect the lead to the flight
battery making sure the red dots are aligned.
The transmitter can be in either the ON or OFF
position while charging a battery.
If the battery is charging correctly, an LED will
glow will light, yellow on the transmitter or green
on the USB lead. When charging is complete, this
LED will go off. It will take approximately 25-40
minutes to charge a fully discharged battery.
Transmitter Battery Check
When charging with the power switch in the
ON position, the signal that the AA transmitter
batteries need to be replaced will be an audible
beep. When charging with the power switch in
the OFF position, the yellow light will become dim
when the AA transmitter batteries are running low.
Note: If you are flying your model while the
transmitter battery power becomes low, stop
flying immediately and replace the batteries in the
transmitter.
Install the Transmitter Batteries
Open the rear cover of the transmitter. Insert the four AA batteries
noting the polarity of the batteries molded into the transmitter case.
Replace the cover on the transmitter.
Check for proper operation of the transmitter by switching the power
switch on (slide it to the right). You should hear three beeps/tones
from the transmitter while the 'POWER' LED indicator begins to glow
solid red. This indicates the transmitter is powered on and the AA
batteries are installed correctly.
Make sure that the coloured dots are lined up on
the battery and charge lead. Plugging the battery
in the wrong way round may damage the pins on
the battery and is not covered by the warranty.
Install the Flight Battery
Always turn the transmitter ON before installing
the Lipo into the model.
Once the flight battery has charged, insert the
battery in the battery holder as shown. Ensure
the red dots are aligned.
Make sure the connector on the battery is aligned
properly to the plug in the fuselage. Take care
not to force the battery in the fuselage. Use only
the supplied battery or Nano Stik replacement
part. Other batteries may damage the radio
system.
Advertisement
Table of Contents
