Table of Contents
Advertisement
chaRging the fLight BatteRy
Mains power supply
(only included in RTF
complete set)
The charger is designed to automatically charge the LiPo battery in about an hour from a discharged state. The 12V
DC automatic charger is powered by the mains power supply illustrated above. Alternatively, you can use a 12V
sealed modelling battery to power the DC automatic charger.
1.
Connect the charger to the power source.
The power LED will light Red and the charge
LED will light Green.
2.
Plug the white 3-pin connector on your Li-po
battery into the 3pin socket in the front of the
charger.
charging: Charge LED flashes Red.
Fully charged: Charge LED is solid Green.
If the charge leD is solid red when you plug in the
battery no charge is needed.
3. When the battery is fully charged disconnect the
battery from the charger. Disconnect the 12V
power source from the charger. Your Li-po is
ready for use.
P47 Thunderbolt Instruction Manual
12V Charger
(Only included in RTF
complete set)
LiPo Battery
5
Advertisement
Table of Contents
